Sizam
25-Nov-2011, 21:44
I was trying to install my Schneider 120mm HM lens on a board today and noticed it wasn't sitting flush, I removed it from the board and saw this screw protruding which prevents the board from sitting flat (the flat head one in the black area):
http://sams.smugmug.com/Other/BlueHarvest/i-rrCN2xp/0/XL/CA11251120453814-XL.jpg
I looked at a couple other of my Schneider lenses and there is a hole where that screw would be but there isn't a screw there (and the board sits flat). Whats up with that screw? Can I remove it, should it go in further, am I doing it wrong ? :)
http://sams.smugmug.com/Other/BlueHarvest/i-rrCN2xp/0/XL/CA11251120453814-XL.jpg
I looked at a couple other of my Schneider lenses and there is a hole where that screw would be but there isn't a screw there (and the board sits flat). Whats up with that screw? Can I remove it, should it go in further, am I doing it wrong ? :)