View Full Version : linhof angulon 90mm hole size?
Hagai Kaufman
3-Nov-2001, 03:36
Hi everyone,
I think that this question had been asked before, but I can't find any thread ab out it, so here we go: can I fit my linhof angulon 90/6.8 on a copal #0 linhof/wista board, or do I nee d to find something with a smaller hole?
Thanks in advance,
Hagai Kaufman
Walter Glover
3-Nov-2001, 05:04
Hagai,
The determining factor is the shutter name and size rather than the lens type.
WG
Hagai Kaufman
3-Nov-2001, 06:09
The shutter is Synchro compur - it has no other designations.
andrea milano
3-Nov-2001, 10:08
You are right this shutter uses a smaller hole the the usual copal 0 I have one and it looks smaller than the usual 0 . Maybe a 00 hole would do or could be slightly adapted. Mine is mounted on a custom made linhof plate.
Thomas Vaehrmann
4-Nov-2001, 23:43
Hi,
I've got the same lens and it mounts without any problems in #0-hole. Diameter should be 25mm.
Mark Wiens
6-Nov-2001, 18:10
I recently purchased a Schneider 90mm f/8 Super Angulon with a Synchro Compur shutter from ebay. It came in a recessed Linhof lensboard. I have a Toyo 45CX. Will the Toyo recessed lensboard with Copal #0 work for this setup with ease? I am a beginner and would like a simple solution. Thanks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.