Jean Nightingale
14-Oct-2006, 12:34
Hello everyone
I have bought a Paterson Orbital Print Processor to develop my 5x4 film. Could anyone give me some instructions on how to use it. It looks like I fit the 4 sheets of film into into each corner, fit the lid,(in a dark room or bag)pour in the chemicals through the circular dome on top, agitate for required minutes, and then I presume tilt the box so it pours out of the arrow corner.Presumably I then repeat for stop and fix. Is this correct and are there any pitfalls I should avoid. I presume film will stay in place when I tip. Not sure how much chemicals to use.
Thanks in advance for any advice
Jean
I have bought a Paterson Orbital Print Processor to develop my 5x4 film. Could anyone give me some instructions on how to use it. It looks like I fit the 4 sheets of film into into each corner, fit the lid,(in a dark room or bag)pour in the chemicals through the circular dome on top, agitate for required minutes, and then I presume tilt the box so it pours out of the arrow corner.Presumably I then repeat for stop and fix. Is this correct and are there any pitfalls I should avoid. I presume film will stay in place when I tip. Not sure how much chemicals to use.
Thanks in advance for any advice
Jean