View Full Version : Piece fell out from my Grafmatic
Spare Tire
25-Sep-2021, 04:29
https://youtu.be/Ir2W_YCLQMg
So what do I do with this metal piece with a bit of velvet cloth attached to it?
You really should put it back as this is a light seal.
Conrad . Marvin
25-Sep-2021, 06:44
Goes under the center bit with the “patent info 4x5 printing “ not in the end. But, I have not had one of these apart in a really long time. I would carefully remove the two screws on each side and pull the two halves apart. Then maybe you can see better what’s what. Nothing to loose.
Alan9940
25-Sep-2021, 06:50
It's been quite awhile since I've disassembled a Grafmatic, but that piece looks like the felt light seal that sits under the septum tray where it slides in/out. Kind of hard to explain here. If you PM your email address, I can send along a service manual which should help you fix it.
Gord Robinson
26-Sep-2021, 18:28
This may be of help
http://www.southbristolviews.com/pics/Graphic/manual-pdf/grafmatic45service.pdf
Spare Tire
27-Sep-2021, 18:38
felt light seal that sits under the septum tray where it slides in/out
I tried shoving it back under the whole septum tray. It closes and cycles alright but sometimes it slides back out and will jam.
https://youtu.be/zbQOuRbO4fY
I wonder if it's not supposed to be glued down or something. Anyways thanks for the ideas and resources. Will try not being lazy and take it apart when i have a moment.
j.e.simmons
28-Sep-2021, 03:28
Ask on graflex.org.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.