Morten
20-May-2021, 12:46
Hi,
I have a guy which are looking to use said lens (Goerz Wide angle Dagor of 3 5/8” focus or 92.1mm f8) on one of 3d printed WillTravel 4x5 camera. As the camera body is rigid we need to establish the Flange focal distance to +/- few mm as there is some tolerance in the focusing setup.
Been trawling the forum and rest of the internet, so far no luck. Any information would be helpful.
Best Regards
Morten
I have a guy which are looking to use said lens (Goerz Wide angle Dagor of 3 5/8” focus or 92.1mm f8) on one of 3d printed WillTravel 4x5 camera. As the camera body is rigid we need to establish the Flange focal distance to +/- few mm as there is some tolerance in the focusing setup.
Been trawling the forum and rest of the internet, so far no luck. Any information would be helpful.
Best Regards
Morten